 |
Artikel: IBM Drive Fitness Test
19.07.2002 by doelf
Der IBM Drive Fitness Test
Wenn man mit Datenverlusten zu kämpfen hat, kann dies verschiedene Ursachen haben. Eine Möglichkeit, die man nie ausschließen kann, ist ein Defekt der Festplatte. Gerade in modernen RAID-Systemen werden die Datenträger sehr stark beansprucht und Probleme sind nicht selten. IBM erleichtert uns die Fehlersuche mit dem IBM Drive Fitness Test ungemein: einfach das IBM DFT downloaden und ausführen. Das Programm erstellt eine startbare Diskette, mit der man den Rechner dann bootet und die Festplatten prüfen kann. Ein Fehlercode gibt anschließend Auskunft über die Art des Problems. Hier die nötigen URLs:
Liste der DFT Fehlercodes:
© IBM Corporation 2002
0x00 - No Error
Command complete successfully.
0x10 - Test aborted by user.
The current test was cancelled by user and cannot be completed. Rerun the test to conclusion
0x20 - Selected device not present.
The selected device could not be found on the selected port. Check cabling and HDD connectors. If the
drive is not seen by the BIOS or is not spinning
0x21 - ATA Master device not present.
An attempt was made to test an ATA Slave device, but an ATA Master can not be detected. A Master
must be present to test a Slave. Check cabling and HDD connectors.
0x22 - Device Protected,
Selected device is protected by a password. The drive is write and read protected and cannot be tested
0x23 - Format Degraded.
A SCSI low level format was interrupted.
0x30 - Out of memory.
There's not enough memory to execute this program.
0x31 - Wrong parameter.
There is a wrong or unknown parameter.
0x33
Function can not be executed on this device.
0x40 - System interrupts the current operation.
The System has interrupted the current operation, and the function was aborted.
Please exit the program and check if any Power Saving Modes or Cache Programs (like
SMARTDRV.EXE) are active. Disable those features and start this program again.
0x41 - Bad cable.
A data miss compare was detected during the cable test.
0x42 - Drive temperature problem.
The drive has exceeded the drive temperature limit
0x43 - Pending SCSI request.
The ASPI Device driver could not complete the SCSI request block. Check the SCSI configuration
(cabling, termination, Ids etc.).
0x44 - System Vibration
The level of vibration that the drive is experiencing is excessive, check the mounting of the drive in the
system and ensure it is rigidly mounted. If possible try mounting the drive in a different position.
0x45
Low System Performance
0x70 - Corrupted Sector.
A general hard disk drive problem was detected. You can run the "Erase Disk" utility. If a subsequent
test fails again, the drive is defective and should be replaced.
0x71 - Device not ready.
The selected drive is not ready for operation. Check cabling and HDD connectors.
0x72 - Device S.M.A.R.T. Error.
The Self-Monitoring, Analysis and Reporting Technology (S.M.A.R.T.) has detected a drive problem.
The drive may fail soon and should be replaced as soon as possible.
0x73 - Device damaged by shock.
This device was damaged by an excessive shock
0x74 - S.M.A.R.T Self-test failed
An error was detected during S.M.A.R.T. self-test. You can run the "Erase Disk" utility of DFT.
If a subsequent test fails again, the drive is defective and should be replaced
0x75
Defective Hard Disk Drive Component
|
|
